Zinc Plated, Malleable Wire Rope Clips or Wire Cable Clips: These are used to clamp the ends of wire rope or cable. These wire rope fittings are held in place by two nuts. Most of the time to secure wire rope you will need at least two or three wire rope clips to secure the ends to the length of the wire rope. Adding a wire rope thimble to the clip can help lengthen the service life of the wire rope by adding a layer of protection to the rope so it doesn’t get worn as quickly.
Our specialists are standing by and ready to help with your wire rope needs. (Yep real people!).
Call Today! (866) 848-2032 or shop below.
WARNING - Improper use and installation of cast malleable wire rope clips can result in serious injury or death. • NEVER use cast malleable wire rope clips for lifting or suspending ANY load. • Cast malleable wire rope clips are to be used only for non-critical, light duty applications with small applied loads.
Specs for Zinc Plated Wire Rope Clips — (To order click the product above)
Meets the performance requirements of Federal Specification FF-C-450D, Type 1, Class 2** * Based on clean, unlubricated threads. The table above shows the minimum torque required to reach maximum holding power of wire rope clips. **NOTE: 1/16" and 1/8" are not covered by Federal Specification FF-C-450D